This mask is an association between a powder and a chemical solution allowing the mask to set. This mixture makes it possible to maintain a strong water concentration in the mask which adheres closely to the skin (the part of the mask stuck to the skin is in fact a genuine epidermic mold). These two characteristics will involve a phenomenon of osmosis at the epidermic level (i.e. the strong water concentration of the mask will be transfered towards the dehydrated skin). The complexion will be luminous and the skin is extremely flexible.

*of the upper layers of the epidermis.

Application:

In a bowl, pour 2 measures shave of powder (the plastic measurer provided with the powder jar). It is useless to pack the powder by fi lling the platic measurer. Pour then over 2 measures shave of liquid. When the weather is very hot, we advise you to preserve if possible the liquid in a cool area in order to allow the mask not set too quickly and take time to spread it out correctly. Mix at once with a spatula in order to obtain a homogeneous mixture. Apply in layer of approximately 3 mm thickness and make edges in order to facilitate the removal. The mask is rubberized at the end of 10 minutes and is removed at once.

Suggestion:

In the case of a face is larger than the average, add a measure of powder and an additional measure of liquid during the preparation.